Whirlpool ASH09000R, Installation Manual

Page: 16 / 96

13
Introduction for buttons on remote controller
Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel
the Sleep, circulate between these, after electrified, Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool modes; sleep status after run for one hour, the
main unit setting temperature will increase 1
℃
, two hours, setting temperature
increased 2 ℃ , then the unit will run at this setting temperature; In Heat mode:
sleep status after run for one hour, the setting temperature will decrease 1
℃
,
two hours, setting temperature will decrease 2 ℃ , then the unit will run at this
setting temperature.
Sleep 2 is sleep mode 2, that is air conditioner will run according to the
presetting a group of sleep temperature curve.
Sleep 3-the sleep curve setting under Sleep mode by DIY;
(1)Under Sleep 3 mode, press “Turbo” button for a long time, remote controller
enters into user individuation sleep setting status, at this time, the time of remote
controller will display “1hour”, the setting temperature “88” will display the
corresponding temperature of last setting sleep curve and blink (The first entering
will display according to the initial curve setting value of original factory);
(2)Adjust " " and " " button, could change the corresponding setting
temperature, after adjusted, press “Turbo” button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer postion on the
remote control, (that are "2hours" or "3hours" or "8hours"), the place of setting
temperature "88" will display the corresponding temperature of last setting sleep
curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours temperature setting
finished, sleep,curve setting finished, at this time, the remote controller will
resume the original timer display; temperature display will resume to original
setting temperature.
Sleep3- the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting
sleep curve, enter into user individuation sleep setting status, but do not change
the temperature, press “Turbo” button directly for confirmation. Note: In the above
presetting or enquiry procedure, if continuously within 10s, there is no button
pressed, the sleep curve setting within 10s, there is no button pressed, the sleep
curve setting status will be automatically quit and resume to display the original
displaying. In the presetting or enquiry procedure, press "ON/OFF" button, "Mode"
button, "Timer" button or "Sleep" button, the sleep curve setting or enquiry status
will quit similarly.
Press this button to start I FEEL function and " " will be displayed on the remote
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and " " will disappear.
8
SLEEP button
9
I FEEL button