Whirlpool APARTMENT MAINTENANCE SERIES, Service Manual

Page: 49 / 132

41
Water Level Control
The load setting or water level control is determined through the use of an electromechanical pressure
switch which provides a 120VAC signal to the microcontroller. The microcontroller reads the signal
from the water level pressure switch during fill, agitate or drain functions only. Water level changes
during any other function will not be initiated by the control system.
Adjusting the water level control to a higher level during the agitate function will cause the washing
action to stop (no agitation) and the appropriate water valves will be turned on until the newly required
water level is met.
Adjusting the water level control to a lower level during the agitate function will not take affect until the
next water fill takes place. (i.e. No water will be pumped out during agitation.) NOTE: Do not adjust the
screw on the pressure switch.
Fig. 2
TEMPERATURE SELECTOR
Temperature Position No.
1
2
3
4*
CC = Cold Wash and Cold Rinse
WC = Warm Wash and Cold Rinse
HC = Hot Wash and Cold Rinse
WW = Warm Wash and Warm Rinse
Water Temperature Switch
The water temperature switch can select up to four predetermined Wash and Rinse water tempera-
ture combinations.
Rinse water temperatures are limited to warm and cold to improve energy efficiency.
Start/Pause Button
The START/PAUSE button is pressed to start the selected washing action and to pause the machine
during any function. The first time the START/PAUSE button is pressed after a selection is made
initiates the washer operation.
The second time the START/PAUSE button is pushed after the washer has begun running will put the
machine in a Pause Mode. All machine functions will stop and cycle timing will not resume until the
START/PAUSE button is again pressed. The “Paused” mode will be indicated by the blinking of any
one of the LEDs. After 2 hours in the PAUSE MODE, washer will turn off.
Features
A.Bleach Dispenser - Located under the lid in the rear left corner. Pour liquid bleach into this dis-
penser. The washer dilutes and dispenses the bleach during the wash cycle.
B.Liquid Fabric Softener Dispenser - Located at the top of the agitator. Liquid fabric softener is
dispensed at the beginning of the rinse cycle. Fabric softener will only dispense if spin reaches full
speed. Rinse the fabric softener cup under hot water when residue builds up.
C.Lint Filter - Pull the liquid fabric softener dispenser up from the center of the agitator. To clean the
lint filter, wipe around the inner surface with a finger.
* Available with 4 temperature option only.
C B A
Table 3