![background image](http://html.mh-extra.com/html/whirlpool/acm938ba/acm938ba_manual_434725004.webp)
Electrical connection must be made before connecting the appliance to the electricity supply.
Installation must be carried out by qualified personnel who know the current safety and installation regulations. Specifically, installation must be
carried out in compliance with the regulations of the local electricity supply company.
Make sure the voltage specified on the data plate located on the bottom of the appliance is the same as that of the home.
Regulations require that the appliance be earthed: use conductors (including the earth conductor) of the appropriate size only.
CONNECTION TO THE TERMINAL BLOCK
For the electrical connection, use an cable as specified in the table below.
SUPPLY VOLTAGE
CONDUCTORS
AMOUNT x SIZE
220-240V ~ +
3 x 4 mm
2
220-240V 3~ +
4 x 1,5 mm
2
380-415V 3N~ +
5 x 1,5 mm
2
380-415V 2N~ +
4 x 1,5 mm
2
ATTENTION:
the power supply cable must be long enough to allow the cooktop to be removed from the worktop and must be positioned so as to
avoid damage or overheating caused by contact with the base.
NOTE:
the yellow/green earth wire must be connected to the terminal with the symbol
and must be longer than the other wires.
•
Remove the terminal cover
(A)
by unscrewing the screw and insert the cover into the hinge
(B)
of the terminal.
•
Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal.
•
Secure the power cable with the cable clamp.
•
Close the cover
(C)
and screw on the terminal with the screw removed.
For each connection to the network, the hob automatically checks for a few seconds.
220–240 V~
380–415 V 3N~
230–240 V ~
(AUSTRALIA ONLY)
220–240 V ~
(UK ONLY)
220–240 V 3 ~
(BELGIUM ONLY)
380–415 V 2N ~
(HOLLAND ONLY)
380–415 V 2N~
230
V
230
V
230
V
230
V
230
V
230
V
230
V
230
V
230
V
230
V
230
V
IMPORTANT:
•
Based on the wiring diagram (see figure) either keep or remove the metal jumpers between the screws on the terminal block L1-L2 and N1-N2.
•
If the cable is provided, see the connection instructions attached to the cable.
•
Connect the appliance to the power supply by means of a multipole switch with minimum contact gap of 3mm.
Example of jumper present (left) or removed (right). See the wiring diagram for details (the jumpers can be between L1-L2 and between N1-N2).
C
B
A
ELECTRICAL CONNECTION