3-19
7.
To remove the compressor:
a) Remove the overload protector (see
step 6 on page 3-18 for the procedure).
b) Disconnect the white wire from com-
pressor terminal pin R, and the brown
wire from pin S.
c) Remove the rubber gasket.
d) Braze on an access valve and dis-
charge the refrigerant into an approved
recovery system.
e) Disconnect the high side line from the
compressor and the suction line from
the accumulator.
f) Remove the cap nut from each of the
feet and lift the compressor off the
studs.
g) Remove the three rubber isolators from
the compressor.
Brown Wire (S)
White Wire (R)
Rubber Gasket
Suction Line To Accumulator
High Side Line
To Compressor
Rubber Isolator
Cap Nut
Summary of Contents for ACD052MM
