Whelen Engineering Company E-2010, Operation & Installation Manual

Page: 9 / 22

5
BATTERY/AC Request battery voltage and AC line voltage.
STATUS REQ Request the Status byte.
S/N STAT Request signal to noise measurement.
S/N REQ Executes the signal to noise check in the Remote Siren.
SIREN OFF Disable the Tone Generator, digital voice is active.
SIREN ON Enable the Tone Generator.
DIS-ARM Disable the Instant Status response.
ARM Enable the Instant Status response.
COUNT CLR Clear the software tone activation counter to zero.
COUNTER Request the software tone activation count.
STROBE TEST EAS only. Strobevisor test.
STROBE OFF De-activate a strobe through the Strobe Control Board.
STROBE ON Activate a strobe through the Strobe Control Board.
TEST CLEAR Clear LEDs and status.
ACTIVE STATUS Request multiple system status parameters.
The eight small buttons are used to configure the control system. The programmable choices are
presented on the display. In general, the Up and Down arrows scroll between the choices, and the Left or
Right arrows toggle between the available choices, such as On or Off.
Note that in Auto Call Setup the Left and Right arrows scroll between the choices and the Up or Down
arrows toggles between YES or NO.
PORT SETUP
Setup for the RS-232 communication port and the Printer port. The RS-232 port is dedicated to a PC
operating Whelen supplied software. The parameters are:
PRINTER ON or OFF Use the Left or Right arrow to toggle.
SERIAL PORT ON or OFF Use the Left or Right arrow to toggle.
Printing and serial interface are discussed in other sections. Set to OFF if not used.
POLLING SETUP
Setup for Status polling routine. This is a list of all of the remote siren address in the system. Unused
entries display as “EMPTY”. To delete an entry, select “ALL”.
AUTO CALL SETUP
Setup for automatic Time-of-Day Call Keys. A Call Key may be programmed to activate by day of the
week and by the time of day. Time is entered as military time (24 hour time). The Call Key must still be
programmed in the CALL KEY SETUP section. The Time-of-Day Call Keys are referred to as Call Keys
#61 and #62.
Use the Left or Right arrows to scroll through the days of the week. Use the Up or Down arrows to toggle
between Y to select the day or N to not select the day. The days are Sunday through Saturday. To get to
the time, scroll right past the last S, for Saturday. Enter the activation time, in military (24 hour time),
from the numeric keypad. Use the Left or Right arrows to move from time to the other Call Key. Do not
use the scroll arrows in the time section, unless moving to the other Call Key. Press ENTER to save the
setup.