Whelen Engineering Company E-2010, Operation & Installation Manual

Page: 14 / 22

10
REMOTE INPUT CALL KEYS
The E-2010 may be activated from four
remote inputs. The typical remote input
circuit is shown. A contact closure, capable
of sinking at least 10 mA, will activate the E-
2010. The closure must remain active for a
minimum of 1/2 a second.
The remote input activates Call Keys #57,
#58, #59 or #60. These Call Keys are
programmed just like Call Keys 1-56, as
previously described.
TIME-OF-DAY (Automatic) CALL KEYS
There are two Call Keys that will automatically activate based on the day of the week and the time of the
day. Refer to Auto Call Setup for more information.
These Call Keys are #61 and #62. These Call Keys are programmed just like Call Keys 1-56, as
previously described.
COMMAND NUMBER TABLE
00 = Cancel 49 = Voice Message 1 09 = North 15 = Silent Test
01 = Wail 50 = Voice Message 2 10 = East 63 = Active Status
02 = Attack 51 = Voice Message 3 11 = South 30 = Test Clear
03 = Alert 52 = Voice Message 4 12 = West 57 = Strobe On
04 = Public Address 53 = Voice Message 5 13 = Clockwise 58 = Strobe Off
05 = Air Horn 54 = Voice Message 6 14 = Counter Clockwise 37 = Strobe Test
06 = Hi-Lo 55 = Voice Message 7 21 = Rotor Position 22 = Counter
07 = Whoop 56 = Voice Message 8 23 = Counter Clear
08 = Noon Test 59 = Voice Message 9 24 = Arm
60 = Voice Message 10 25 = Dis-Arm
61 = Voice Message 11 26 = Siren On
62 = Voice Message 12 27 = Siren Off
17 = Voice Message 13 28 = S/N Request
18 = Voice Message 14 29 = S/N Status
19 = Voice Message 15 31 = Status Request
20 = Voice Message 16 33 = Battery/AC
34 = Battery/Temperature
35 = Instant Status
560
330
18 Volt
12V
CONTACT-
Clamp
NOTE:
Any active Call Key may be terminated by pressing CALL KEY
CANCEL. The E-2010 will return to the standby screen.