13
Alarms
There are two remote siren conditions which will cause an alarm in the E-2010. They are Low Battery
and Intrusion.
Upon receipt of either alarm, the E-2010 sounds the internal buzzer (assuming it is enabled, see AUDIO
in the Menu Selections section) and activates the appropriate output relay. There are two relay closures.
One is for Low Battery and one is for Intrusion. Each closure is rated at 1/2 amp @ 120 VAC or 1 amp
@ 24 VDC. The connections are described in the Installation section.
Pressing ALARM ACK silences the buzzer and turns off the relay.
PC Interface
If desired, the E-2010 can interface with a personal computer (IBM compatible running Windows 95)
through an RS-232 Serial Communication port. Software is included to allow for the following:
Storing data to the hard drive.
Selectable printing, based on site or date.
Call Key programming (instead of using the E-2010 keyboard).
Call Key descriptions.
Storing data in a format compatible with Microsoft Access.
Follow the installation instructions on the CD-ROM to install and operate the interface software. Use the
9 position D connector cable to connect the Serial port of the E-2010 to a Serial communication port on
the PC.
Note:
The E-2010 operates independent of the PC. Therefore, even
if the PC is doing something else or is
off
, the E-2010
continues to operate normally.
Summary of Contents for E-2010
Page 22: ......
