Page 6
Input Expansion Table
Positive Input 2
Positive Input 8
RED
GREY
2
8
3
9
13
5
11
15
4
10
14
6
12
16
Positive Input 6
Negative Input 4
Negative Input 8
BLUE
WHT/YEL
WHT/GRY
GREEN
WHT/ORG
WHT/VIO
ORANGE
WHT/BRN
WHT/GRN
YELLOW
WHT/RED
WHT/BLU
Positive Input 4
Negative Input 2
Negative Input 6
Positive Input 5
Negative Input 3
Negative Input 7
Positive Input 3
Negative Input 1
Negative Input 5
1
7
BROWN
VIOLET
COLOR
FUNCTION
Positive Input 1
Positive Input 7
WIRE CHART
WIRE SIDE VIEW
POS
1
9
2
3
4
5
6
7
8
10
11
12
13
14
15
16
Input Expansion Module (optional)
The optional input expansion module enables up to eight (8) non-CenCom
vehicle components and/or equipment to be integrated into the CenCom/
Cantrol network.
As shown in the tables below, connect the input wire of the desired device
to the appropriate wire. For example, if the device in question requires a
Positive input signal, that input wire would be connected to the BROWN
expansion module pigtail wire. In this example, that device would be
recognized as “INPUT 1” by the CenCom/Cantrol system. However, if that
device requires a Negative input signal, that input wire would be
connected to the WHT/BRN expansion module pigtail wire. Note that this
device would be recognized as “INPUT 1” by the CenCom/Cantrol system.
Control Head Strain Relief
1.
Route the control head cable (provided) from
the CanTrol™ module to the designated
mounting location. Plug this cable securely into
the rear of the control head. Be sure to route
the cable through either of the two recessed
pathways (shown here). This will prevent the
cable from being accidentally disconnected or
pinched by the control head.
Cntrl Hd
Cntrl Head
Cable Strain
