and switches on and off automatically (See Fig 1). Suitable for a primary bilge pump
for boats smaller than 12 metres/39.4 ft (designed to ISO15083), or as a secondary
bilge pump on any recreational marine vessel.
Read the following instructions carefully.
Check that the product is suitable for the intended application, follow these installation
instructions and ensure all relevant personnel read the points listed below. Also
ensure that these operating instructions are passed on to the end user.
Gulper® IC is designed for installation in recreational marine vessels only and
operated on 12 or 24 V d.c. electrical supply only. If it is intended for use for any other
purpose or with any other liquid, it is the user's responsibility to ensure that the pump
is suitable for the intended use and, in particular, that the materials are fully
compatible with the liquids to be used. The Whale Gulper® IC pump is
not
recommended for domestic applications.
•
This pump
must not
be mounted below the water line when
connected to an intake or outlet unless the system has a
vented loop (see Fig 1).
•
Not suitable for pumping flammable liquids, diesel,
chemicals etc. Suitable for bilge water only.
•
NOTE
: Bilge pump capacities may not be sufficient to prevent flooding
from rapid accumulation of water due to storms, rough weather and/ or
rapid leaks created by hull damage and or unsafe navigational conditions.
•
With all applications, it is important that a system of safe working practice
is applied to installation, use and maintenance. Ensure the electric supply
is turned off and waste water system is drained before installation. In order
to securely fasten the unit, ensure that the mounting surface is a minimum
thickness of 19mm (3/4") (when fitted with the screws supplied).
•
NOTE
Do not screw directly to the hull - must be mounted on a bulkhead
or on an additional board.
•
NOTE - DO NOT
unscrew the rear section, as interference with the
internal electrics will render the pump unfit for use. - this is a non-
serviceable part of the pump.
•
WARNING:
Fire hazard. Wiring must comply with applicable electrical
standards and include a properly rated fuse or circuit breaker (See section
11v.) Improper wiring can cause a fire resulting in injury or death. Switch
off the power while making connections.
6. TO THE FITTER
7. APPLICATION
8. WARNINGS
5. TO THE USER
