Suggested wiring information is given as a guide only. For full information, refer to the
USCG, ABYC and ISO regulations for marine applications and wiring gauges,
connectors and fuse protection.
Contact Whale® Support team for further technical 44 (0)2891 270531 or
email: [email protected]
Qty 1
Gulper® IC bilge pump
Qty 1
Strainer IC
Qty 3
No.8 self tappers and washers
Qty 1
Inline fuse assembly
AK2050 - Service kit - Replacement head for all Gulper® pumps
AK2086B - Deutsch® Connector Extension Cable 6m (18ft)
NOTE
: Incorrect installation will invalidate warranty
Preparation - Always disconnect power sources before installing.
11.i Location
•
Choose a position to mount the pump that is dry and away from standing
water and is free from obstacles.
•
Mount in a position with the shortest possible pipe run lengths.
11.ii Mounting Instructions - Gulper® IC
•
Gulper® IC can be mounted on a horizontal or vertical surface.
•
When mounted vertically ensure that the pump head is lower most (see
Fig 2).
NOTE
-It is recommended that the outlet is mounted above the water line and anti-
syphon loops are fitted where applicable- see typical installation (Fig. 1)
•
When mounting, position the pump on surface and work out the best
angles for the hose (to prevent kinking) and mark the 3 hole positions
using the pump feet.
•
NOTE:
The pump head may be rotated to suit the hose connections.
9. PARTS LIST
10. OPTIONAL EXTRAS
11. INSTALLATION
Fig. 2 - Pump Orientation
