WD-90GR FLEX / HC
Rev. 4.0 (202206)
Operating instructions
52
4.3.4
Weekly cleaning or as required
Collecting the granules
The granules must be collected and cleaned once a week. This is done before the
machine is emptied and turned off.
To collect the granules, replace the filters with the connector plates (A) and the
granule collector (B).
•
Remove the rotating table (16) and the filter (14).
•
Put the granule collector (B) where the filters are normally located and the
two connector plates (A) on each side of the collectors.
•
Run programme P1 with granules.
•
When the programme is finished, remove the granule collector (B) and the
two connector plates (A). Check that all the granules have been collected.
•
Check that the collector contains the correct amount of granules. The col-
lector should contain around 5 litres of granules. The granule collector
should be full to the brim. Add fresh granules if necessary.
•
The machine checks that the machine contains the correct quantity of gran-
ules after a specific number of wash cycles (may be set).
•
Leave the granules in the collectors overnight to air.
•
Put it back in the granule wash tank (13) the next day.
B
A
A
90_11
Summary of Contents for WD-90GR FLEX
Page 2: ......
