WD-90GR FLEX / HC
Rev. 4.0 (202206)
Operating instructions
22
4.1.2
Preparations before filling
Check:
•
The machine and removable parts have been cleaned. If not – clean them!
•
That no dirt is in the washer arms’ (19) or in the rinse pipes’ (23) nozzles
•
That the wash tank (12) is completely free from granules. Granules in the
wash tank can cause a water leak round the rubber sleeve on the level pipe
(22).
•
That there are sufficient granules in the granule wash tank (13). The tank
should contain 5 litres of granules.
•
that removable parts are correctly in place. Level pipe (21), filter (14), cover
plates (15) and that the level pipe’s rubber sleeve (22) is against the bottom
plate.
•
amount of detergent and drying agent (option)
•
That the stopcock for the water to the machine is open
•
the power switch is in the ON position
Detergent and drying agent
•
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable deter-
gent. Washing-up liquid causes a build-up of foam, produces poor wash re-
sults and can damage the machine.
•
Steel wool must not be used for pre-treating the dishware.
•
Only detergent and drying agent intended for industrial machines may be
used.
•
If using liquid detergent and drying agent, the same make and type of de-
tergent and drying agent should be used.
•
If the machine is equipped with a condensing unit, dishware should be re-
moved from the machine as soon as the wash cycle is complete so that re-
condensation does not occur.
•
Different makes of granules differ in both size and weight. The machine is
designed to use Wexiödisk original granules. The amount to be added to
the machine is indicated under “TECHNICAL SPECIFICATIONS”
4.1.3
Filling and heating the machine
When filling the machine with water, you should not have any items in the ma-
chine. Water which is hotter than for normal washing is flushed into the wash com-
partment when the machine is being filled. This can result in food residue getting
burnt onto any items in the machine, giving a poorer wash result.
•
Press button (6) to switch on the power supply.
•
Press one of the programme buttons P1, P2 or P3 (10).
•
Close the door. The machine will start to fill with water.
•
Messages indicating the sequence of events appear on the display (1).
N.B.! The time needed to heat the water to the right wash temperature depends
on the temperature of the incoming water.
Summary of Contents for WD-90GR FLEX
Page 2: ......
