EASY 6000
– Issue 02
29
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI)
– tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: [email protected]
E
N
G
L
I
S
H
8.4
USE OF COINMECHANISM BDV 001
The coin mechanism must only be connected/disconnected with the machine
switched off.
After having carried out the connection, switch on the machine, enter the programming and set
command 69
to 4
, then switch off the machine for some seconds. By switching it on again the machine and the coin
mechanism will communicate correctly.
Command 30
Purchase obligation before return
(def. 0)
Command 31
Maximum credit
(def. 0)
Command 32
Maximum value of returned coins
(def. 0)
Command 33
Inhibition single coins
(all enabled)
Command 34
Coin inhibition with exact amount
(all enabled)
Command 35
Coin level message exact amount
(def. 0)
Command 36
Equation exact amount
(def. 0)
Command 37
Enabling credit card reader
(def. 0)
Command 38
Emptying of change giving tubes
Command 39
Filling up of change giving tubes
Command 30 Purchase obligation before return:
By setting this command to 1 the customer is obliged to purchase before receiving back the return. This is to
avoid to use the coin mechanism as a coin-changer. If the purchase fails to happen, the return will be given
out.
Command 31 Maximum credit:
The maximum credit accepted by the coin mechanism is set. By overtaking this value the acceptance of
further coins is blocked.
Command 32 Maximum value of returned coins:
This function is active only in multi-sale. If the value of the credit which remains after a sale is higher than the
value set by the command, the allotment of return will be blocked. Therefore it will be necessary to carry out
further purchases until the remaining credit will be lower than the set value. By moving the return lever it will
be possible to obtain the return.
Command 33 Inhibition single coins:
The acceptance of particular coins by the coin mechanism will be blocked through this command. If you want
to block the acceptance of coin 5, proceed as follows:
1. Programming mode, display views........................................................................................... Command 00
2. Dial 33 and press ENTER, display views .................................................................................... Coin no. 00
3. Dial 5 and press ENTER, display views ....................................................................................................... 0
4. Dial 1 and press ENTER.
Summary of Contents for Easy 6000
Page 1: ......
