Figure 85: Installing Burner Cover Support Kit
Figure 86: Permanent Magnet on
Right Burner Cover Support.
i
nStallation
S
et
-u
P
Figure 87: Slots in Back of Burner Cover.
Figure 88 Installing Burner Cover.
10. Install the Glass Burner Cover Support Kit to the Right Burner Support using three (3) T-20 Torx screws
supplied. Install the Support Kit to the Left Burner Cover Support as you’ve done on the right side.
11. Place one of the Permanent Magnets provided on the front edge of the Burner Cover Supports as
shown in Figure 86.
12. The Burner Cover has two (2) slots, one the either side of the rear flange (refer to Figure 87). These
slots fit over the two (2) studs in the burner cover support (refer to Figure 86) to keep it in place.
The arrows in Figure 88 point at the studs that hold the Burner Cover in position. Place the Burner
Cover over the pins and then once aligned with the holes, push the Burner Cover back towards the
rear of the firebox. The front of the Burner Cover is held in place by the permanent magnets installed
in step 11.
13. Install the Glass Tray and the Glass to complete the installation
42
