W
ESTFIELD
- MKX100-S
ERIES
G
RAIN
A
UGERS
3. A
SSEMBLY
MKX100-53/63/73/83
30908 R3
51
3.10. CONNECT THE PTO DRIVELINE
1. Install the PTO transport bracket using two 1/2” x 1-1/4” bolts (19588) and
two 1/2” nuts (19599).
2. Clean paint or dirt off of PTO driveline and flighting shaft ends before
assembly.
3. Ensure that the 1/4” x 3-3/8” square key is in place on the flighting shaft.
4. Slide plain end of PTO driveline onto flighting shaft. Make sure that the
5/16” holes are lined up.
5. Carefully tap in a 5/16” roll pin. Tighten the set screw on the PTO shaft.
6. Loosely install the sprocket shield on the boot using four 5/16” x 3/4” bolts.
7. Slide the PTO transport saddle through the support strap on the boot and
rest the PTO driveline in it.
8. Tighten the sprocket shield bolts.
Figure 3.35 PTO Parts and Installation
TRANSPORT BRACKET [20042]
1/2” X 1-1/4” BOLTS [19588]
1/2” LOCKNUTS [19599]
PTO TRANSPORT
SADDLE [18754]
5/16” ROLL PIN
[18079]
PTO
SPROCKET
SHIELD
SQUARE KEY
5/16” X 3/4” BOLTS [19538]
Summary of Contents for MKX100 SERIES
