16
INSTALLATION & TECHNICAL MANUAL
CONFIGURATION & OPTIONS
The Aurora uses two banks of Dip Switches on the Controller board (SW 3 &
SW 4) to set-up the configuration and options.
CONFIG SWITCHES
The “CONFIG” bank of dip switches (SW 3) is for the following features:
Switches 1 & 2: Daytime Brightness
There are 4 selectable brightness levels. The built-in photo sensor automatically
detects daylight conditions and sets the display brightness to this level.
BRIGHTNESS LEVEL
SWITCH 1
SWITCH 2
High (Default)
ON
ON
Medium-High OFF ON
Medium-Low ON OFF
Low OFF
OFF
Switches 3 & 4: Nighttime Brightness
There are 4 selectable brightness levels. The built-in photo sensor automatically
detects nighttime conditions and sets the display brightness to this level.
BRIGHTNESS LEVEL
SWITCH 3
SWITCH 4
High ON
ON
Medium-High OFF ON
Medium-Low ON OFF
Low (Default)
OFF
OFF
NOTE: Dip Switch settings take effect only after the Aurora has
been reset (Cycle power directly or press the “RESET” button).
NOTE: Lowering the brightness level at night helps reduce
nighttime glare and energy costs. Passing headlights,
spotlights, etc. will NOT activate the daytime brightness level.
Summary of Contents for AURORA 45
Page 1: ......
