User Guide
4. Management
4.7 Zoning
Note:
A comma should be placed after each bit of data in the IOM SAS
Address that was recorded. For example, if the IOM SAS Address output
was
5000CCAB0300003C
, the address that should be added to the
sg_senddiag command should be
50,00,CC,AB,03,00,00,3C
.
b.
Use the example of the sg_senddiag command shown in the image above to complete the
specific sg_senddiag command for IOM B. Replace letters
a
through
d
with the information
recorded in previous steps.
sg_senddiag Command
sg_senddiag <a> --pf --raw=04,00,00,90,<b>,<c>,00,00,<d>
a. SCSI device (<dev>)
: device associated with IOM B
b. Enable Zoning
: 61
c. Zoning Configuration
: configuration 01, 02, or 03
Note:
For information on preconfigured zoning configurations, see:
Predefined Zoning Configurations
d. IOM SAS Address
: SAS Address associated with IOM B
Note:
A comma should be placed after each bit of data in the IOM SAS
Address that was recorded. For example, if the IOM SAS Address output
was
5000CCAB0300007C
, the address that should be added to the
sg_senddiag command should be
50,00,CC,AB,03,00,00,7C
.
c.
The following are examples of completed sg_senddiag commands for IOM A and B.
•
IOM A
: sg_senddiag 3 --pf --raw=04,00,00,90,61,01,00,00,50,00,CC,AB,03,00,00,3C
•
IOM B
: sg_senddiag 106 --pf --raw=04,00,00,90,61,01,00,00,50,00,CC,AB,03,00,00,7C
Step 5 :
Enable zoning on IOM A using the sg_senddiag command.
a.
Issue the command for IOM A that was built in the previous step.
b.
Enabling a predefined zoning configuration will reset the SAS connector ports which may
cause the sg_senddiag command to return a status of DID_TIME_OUT or DID_SOFT_ERROR.
Despite the error, the zoning configuration will be enabled. The zoning configuration can
be verified after both IOMs have been zoned.
send diagnostic: transport: Host_status=0x03 [DID_TIME_OUT]
Driver_status=0x00 [DRIVER_OK]
Step 6 :
Enable zoning on IOM B using the sg_senddiag command.
a.
Issue the command for IOM B that was built in the previous step.
b.
Enabling a predefined zoning configuration will reset the SAS connector ports which may
cause the sg_senddiag command to return a status of DID_TIME_OUT or DID_SOFT_ERROR.
Despite the error, the zoning configuration will be enabled. The zoning configuration can
be verified after both IOMs have been zoned.
236
