030-300198 Rev. D
55
March 2003
WireSpeed Dual Connect NAT Router
User Guide
If you selected
Public LAN Enable,
or
if you made other changes in the
Public LAN Configuration
screen and
clicked on
save
, the following pop-up screen will be displayed. Click on
OK
to save the new settings. If you click
on
Cancel
, your new settings will not take affect.
NOTE: DHCP Lease Time is displayed in the following format: (dd:hh:mm:ss)*. (This value must be greater than
10 seconds.) The default = 01:00:00:00. Seconds must be between 0 and 59, minutes must be between 0 and 59, and
hours must be between 0 and 23.
*(dd = days, hh = hours, mm = minutes, ss = seconds).
If the settings you have entered in the
Public LAN Configuration
screen are incorrect, the following warnings
messages may be displayed via pop-up screens. If this occurs, check settings in the
Public LAN Configuration
screen.
Warning Message
Check Public LAN DHCP Settings
Start Address is not part of the Subnet
Check the value in the DHCP Start Address field
End Address is not part of the Subnet
Check the value in the DHCP End Address field
End Address is below the Start Address
Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds
Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 53
Check the
Seconds
field at DHCP Lease Time
Minutes must be between 0 and 59
Check the
Minutes
field at DHCP Lease Time
Hours must be between 0 and 23
Check the
Hours
field at DHCP Lease Time
If you clicked on
OK
in the
Load new Public LAN configuration?
pop-up
screen, the following pop-up screen
will be displayed. Click on
OK.
This will allow the modem to be reset, and the new configuration will take affect.
