44
West Mountain Radio
Operating Manual
/termperatureF
n
n specifies the temperature in Fahrenheit to stop the test, to prevent test from run
-
ning if external temperature is too high.
All tests support stopping at the specified temperature (n) however, not all tests
support temperature graphing. Temperature will be graphed if the selected test
supports it and saved to file (/open).
/graph
AmpHrs
WattHrs
Minutes
Ragone
Amps
Watts
If performing a hands-free test (/test), this specifies the graphing format to be
used. Ragone graphing only works for discharge tests. Amps and Watts are only
available for PowerProfile tests
/amplifiers
n
For a hands-free test, specifies the number of CBA Amplifiers connected to the
system. If this is not specified, it is assumed 0.
/unit
Serial
For multiple CBA operation, this is an optional argument to specify which CBA to
use.
Example:
/unit 40100
/chargeunit
Serial
For multiple Charger Interfaces this is an optional argument to specify which
Charger Interface to use
Example:
/chargeunit 45999
/chargegraph
For Charge Discharge Test: If specified, will graph Voltage during charge portion
of test
Example:
/chargegraph
/graphcurrent
For Charge Discharge Test: If specified, will graph Current during charge portion
of test.
This will be ignored without “/chargegraph”
Example:
/chargegraph /graphcurrent
/chargeignore
time
For Charge Discharge Test: Delay time in seconds to ignore input signals on
Charger Interface. DEFAULT: 0 seconds
Example:
/chargeignore 20
/chargerecovery
time
For Charge Discharge Test: Delay time in seconds between charge and discharge
portions of test. DEFAULT: 60 seconds
/chargeamphrlimit
AmpHrs
For Charge Discharge Test: During charging phase this parameter will stop the
cycle after the specified number of AmpHrs.
Example:
/chargeamphrlimit 2.800
