6
2.
Slide the Upright (3) onto the M10 x 65mm
Carriage Bolts (56) in the Base (1). Hand tighten
an M10 Nylon Locknut (68) onto each Carriage
Bolts.
Do not tighten the Nylon Locknuts yet.
Press a 25mm Square Inner Cap (54) into the
Upright (3).
3.
Place two Weight Bumpers (19) over the indicat-
ed holes in the bracket on the Base (1). Insert the
two Weight Guides (16) into the holes and attach
them to the Base with an M10 x 155mm Bolt (76),
two 19mm Spacers (29), two M10 Washers (62),
and an M10 Nylon Locknut (68).
Be sure the
lock holes in the Weight Guides are closer to
the bottom.
Slide the nine Weights (18) onto the Weight
Guides (16).
Be sure the pin grooves are on
the side shown.
Insert the Weight Tube Bumper (25) into the bot-
tom of the Weight Tube (26). Insert the Weight
Tube into the centre hole in the Weights (18).
Lubricate the indicated holes in the Top Weight
(17). Slide the Top Weight onto the Weight
Guides (16).
Be sure the pin groove in the Top
Weight is on the bottom.
2
3
3
54
68
56
1
62
62
76
17
68
29
29
26
25
Pin
Groove
Lock
Hole
19
18
1
Bracket
16
Lubricate
