- -
- 26 -
Put on the flange the calibration tool and, with the cone on the outside, lock it with the quick nut,
make sure that the red dot mark on the calibration tool will match with the one on the flange (Fig.
21).
Fig. 21 Calibration tool mounted on the flange
Close the wheel cover and press
START
to start calibration spin.
When the calibration cycle will end the display will show values 0 and 80 (79 is also accepted)and it
means that the calibration of the machine was well done.
Press
START
again to exit from the CALIBRATION page and enter in a normal balancing mode.
