WERKU WK400950, Original Instructions Manual

Page: 4 / 48

English
ENG
ORIGINAL INSTRUCTIONS
4
measures reduce the risk of starting the power tool
accidentally. Do not use accessories which are not
specifically designed and recommended by Werku.
Just because the accessory can be attached to this
power tool, it does not assure safe operation. The
rated speed of the disc must be at least equal to the
maximum speed marked on this power tool. Discs
running faster than their rated speed can break and
fly apart. The outside diameter and the thickness
of the disc must be within the capacity rating of
this power tool. Incorrectly sized discs cannot
be adequately guarded or controlled. Threaded
mounting of discs must match the spindle thread.
For discs mounted by flanges, the arbour hole of
the disc must fit the locating diameter of the flange.
Discs that do not match the mounting hardware
of this power tool will run out of balance, vibrate
excessively and may cause loss of control. Do not
use a damaged disc. Before each use, inspect the
disc. If this power tool or its disc is dropped, inspect
for damage or install an undamaged disc. After
inspecting and installing a disc, position yourself and
bystanders away from the plane of the disc and run
this power tool at maximum no-load speed for one
minute. Damaged discs will normally break apart
during this test time. Regularly clean this power
tool’s air vents. The motor’s fan will draw the dust
inside the housing and excessive accumulation of
powdered metal may cause electrical hazards.
STORE POWER TOOLS.
Store power tools out of reach of children and
not allow the handling of power tools to people
unfamiliar with the tools or these instructions.
Power tools are dangerous in the hands of
untrained users.
MAINTENANCE.
Check moving parts for misalignment or binding,
there are no broken parts or other conditions that
may affect the operation of power tools. Power tools
are repaired before use when they are damaged.
Many accidents are caused by poorly maintained
power tools. Use power tools, accessories and
tool tips, etc. according to these instructions and
in the manner provided for the particular type of
power tool, taking into account the conditions work
and work to develop. The use of the power tool for
applications other than those intended could result
in a dangerous situation. Please check your power
tool serviced by a Werku
®
official repair service
using only identical replacement parts. This will
ensure the safety of the power tool is maintained.
CHECK CONDITION.
Make sure that all the screws in the jig saw are
perfectly tightened. In cold climates or when the jig
saw has not been used for a period, allow the jig
saw to warm up by leaving it to run empty for a few
minutes, to ensure that all internal components are
perfectly lubricated. Make sure that the possible
installed accessories are perfectly fitted in place.
BEFORE STARTING WORK.
Make sure that the jig saw is firmly supported
before using. Check that no one is standing
beneath you when using the jig saw in high areas.
Keep your hands away from all moving parts of
the jig saw.
DURING THE OPERATION.
Do not leave the jig saw operating without having it
firmly fixed. Only turn it on when you are sure you
have full control over it. Do not point the jig saw at
anyone while in use. When operating the jig saw will
produce vibrations. The screws may gradually come
loose, and possibly cause faults or accidents. Keep
your hands away from all moving parts of the jig saw.
AT FINISH WORKING.
Do not touch the possible accessories installed
in the jig saw after use. It may be hot and cause
burns. Some materials worked with may contain
chemicals or toxic components. Avoid inhaling
these substances or allowing them to come into
contact with your skin. Use PPE designed to
prevent and protect against incidents of this kind.
DESCRIPTION OF THE PRODUCT.
The jig saw has been designed to carry out jobs of
cutting. Refer to this plan to familiarize yourself with
the jig saw before use.
5
8
9
6
3
1
4
2
7