![background image](http://html.mh-extra.com/html/wen/70730/70730_instruction-manual_956563019.webp)
WARNING:
Be sure to read and understand all the specific rules for your miter saw before attempting
to assemble or operate your miter saw.
1. RAISE THE SAW ARM
Before operation, raise the saw arm from the lower position. Slightly press down the saw arm to pull out the release
knob (Fig. 15 - 1) . Raise the saw arm to its full height and release the release knob into the shallow groove.
OPERATION
CROSS CUT:
Miter table 0°, Saw arm 0°
MITER CUT:
Miter table 0 to 45° left or right, Saw arm 0°
BEVEL CUT:
Miter table 0°, Saw arm 0° to 45°,
COMPOUND CUT:
Miter table 0 to 45° left or right, Saw arm 0° to 45°
2. SET UP A CUT
The miter saw can be set up to create cuts at different
angles by adjusting the angle of the miter table and the
saw bevel angle.
To set up the miter table angle:
Push down the miter lock (Fig. 15 - 2) with your thumb
and lift the miter stop lever (Fig. 15 - 3) with your index
finger. Rotate the miter table until the pointer aligns with
angle of your choice on the miter scale. The miter table
features positive click stops at 0°, 15°, 22.5°, 30°, and 45°.
Release the miter stop lever to lock the table at a click
stop. Push up the miter lock to secure the miter table in
place. Check that the table is secured.
To set up the saw arm bevel angle:
Hold the operation handle with one hand and loosen the
bevel lock (Fig 15 - 4) in the back of the machine. Tilt the
saw arm to the desired bevel angle (between 0° and 45° to
the left). Tighten the bevel lock and make sure the saw
arm angle is secured.
Fig. 15
2
3
4
1
Refer to the diagram below for setting up your desired cut.
19
Summary of Contents for 70730
Page 23: ...EXPLODED VIEW PARTS LIST 23 ...
Page 27: ...THANKS FOR REMEMBERING ...