ASSEMBLY AND ADJUSTMENTS
SETTING THE BLADE SQUARE WITH THE TABLE
1. Lower the saw arm to its lower position and lock the release knob.
2. Slide the saw arm to the back and tighten the sliding knob.
3. Set the miter table to 0° and tighten the miter lock.
4. Set the bevel angle to
0°
(leaving the blade at 90° to the miter table)
and tighten the bevel lock.
5. Place a set square (not included) against the table and the flat part
of the saw blade (Fig. 5).
6. Wearing work gloves, rotate the blade by hand and check the
blade-to-table alignment at several points.
7. The edge of the set square and the saw blade should be parallel.
If the saw blade angles away from the set square, adjust as follows.
8. Use a spanner (not included) to loosen the lock nut securing the
0° bevel adjustment screw (Fig 6 - 1).
9. Holding the operating handle, loosen the bevel lock (Fig 6 - 2).
10. Adjust the 0° bevel adjustment screw to bring the saw blade into
alignment with the square.
11. Tighten the bevel adjustment screw and the lock nut. Tighten
the bevel lock.
NOTE: The above procedure can also be used to check the angle of
the saw blade to the table at the 45° bevel angle. The saw blade can
be adjusted at 45° with the 45° bevel adjustment screw (Fig. 6 - 3).
SETTING THE BEVEL SCALE POINTER
1. After setting the saw blade at 90° with the table, loosen the screw
holding the bevel scale pointer (Fig. 7 - 1).
2. Adjust the direction of the pointer so that it accurately indicates
0° on the bevel scale.
3. Tighten the screw on the pointer.
15
Fig. 5
Fig. 6
Fig. 7
1
1
3
2
Summary of Contents for 70730
Page 23: ...EXPLODED VIEW PARTS LIST 23 ...
Page 27: ...THANKS FOR REMEMBERING ...
