1. TO RAISE OR LOWER THE SAW ARM
The saw arm needs to be raised up before operation and
locked down for transporting and storing.
To raise saw arm from the lower position:
Holding the operating handle, lightly press down on the
saw arm and pull out the release knob. Slowly raise the
saw arm to the upper position.
Set the release knob into the deep groove to lock it in
the upper position. Set the release knob into the shallow
groove to prepare for operation.
To lower saw arm from the upper position:
Holding the operating handle, push the blade guard le-
ver and pull out the release knob.
Slowly lower the saw arm to the lower position and lock
the release knob into the deep groove.
2. TO BEVEL THE SAW ARM
The saw arm can bevel from 0° to 45° to the left. Hold
the operation handle and unlock the bevel lock by
turning it down clockwise.
Tilt the saw arm until the pointer indicates the desired
angle on the bevel scale.
Tighten the bevel lock. Make sure the saw arm is locked
in place and does not tilt.
3. TO ENGAGE/LOCK THE SLIDE BAR
The saw arm can be adjusted to extend out to different
lengths using the slide bar. Loosen the slide lock knob
and slide the saw arm to desired position.
Tighten the slide lock knob before transporting the mi-
ter saw and before non-sliding operations.
ASSEMBLY AND ADJUSTMENTS
Without plugging in your miter saw, read through and become familiarized with the following procedures of
handling and adjusting your miter saw.
Slide Lock Knob
Operating Handle
Blade Guard Lever
Bevel Lock
Bevel Scale
Release Knob
Deep groove
Shallow groove
12
Summary of Contents for 70730
Page 23: ...EXPLODED VIEW PARTS LIST 23 ...
Page 27: ...THANKS FOR REMEMBERING ...
