Wen 70730, Instruction Manual

Page: 17 / 27

ASSEMBLY AND ADJUSTMENTS
Blade rotate direction
Cutting direction
Fig. 12
10. Reinstall the outer flange, washer and flange screw. Hold
down the spindle lock (Fig. 10 - 1) and tighten the flange screw
with the allen wrench.
11. Return the arbor safety guard back in place, and tighten it
back onto the screw on the right.
10. Return the guide bar back to position (Fig. 8). Insert the
guide bar screw and tighten. Then reattach the spring onto the
screw.
IMPORTANT:
Rotate the saw blade and make sure that it
does not wobble. Lower the saw arm and check if the blade
spins freely in the table insert in both perpendicular and 45°
angles.
USING THE LASER
A laser line can be projected from the laser (Fig. 13 - 1) onto the
workpiece to provide a reference guide for the cut.
WARNING:
Do not start directly into the laser. Do
not project the laser onto reflective surfaces.
To switch on the laser, move the ON/OFF switch (Fig. 13 - 2)
up to the “I” position. To switch off the laser, move the ON/
OFF switch down to the “O” position.
INSTALLING/REPLACING THE BATTERIES:
1. Switch off the laser to “O” position.
2. Unscrew and open the battery compartment cover (Fig. 13
- 3). Remove the used batteries and replace new batteries (3 x
LR44 Battery). Check that the battery terminals are positioned
correctly when inserting new batteries.
3. Close the battery compartment and tighten the screw.
1
Fig. 13
2 3
17