![background image](http://html1.mh-extra.com/html/wen/56877/56877_owners-manual_956385019.webp)
Electric Start
To start the generator using the electric start function, perform the following steps:
1.
Make sure no electrical devices are connected to the generator. Such devices can make it
difficult for the engine to start.
2.
Check that the generator is properly grounded (see Figure 9, “Ground the Generator”).
3.
Check the oil and gas levels.
4.
Turn the fuel valve to the “ON” position (see figure 10).
5.
Move the choke rod to the “Start” position (see figure 11).
6.
Set the engine switch to the “ON” position.
7.
Turn the engine switch to the “START” position for 2-3 seconds or until the engine starts.
NOTE: If the engine does not start after 2-3 seconds, release the switch from the start position.
Keeping the switch in the START position too long can damage the starter.
8.
If engine fails to start, wait 10 seconds, then repeat step 7. NOTE: After repeated attempts to
start the engine, please consult the troubleshooting guide before attempting again. If problems
persist please call
(800) 232-1195 M-F 8-5 CST
.
9.
Once the engine has started. Slowly move the choke lever all the way to the “Run” position.
Allow the generator to run for several minutes before attempting to connect any electrical devices.
Manual Start
To start your generator using the manual start function, perform the following steps:
1.
No electrical devices should be connected to the generator during starting. Devices can make it
difficult for the engine to start.
2.
Check that the generator is properly grounded (see Figure 9 “Ground the Generator”).
3.
Check the oil and fuel levels.
4.
Turn the fuel valve to the “ON” position (see figure 10).
5.
Move the choke lever to the “CLOSE” position (see figure 11).
6.
Set the engine switch to the “ON” position.
7.
Pull on the recoil starter handle slowly until a slight resistance is felt (see figure 12). Then pull
quickly to start the engine. Return cord gently into the machine. Never allow the cord to snap
back.
8.
If engine fails to start, repeat step 7. NOTE: After repeated failed attempts to start the engine,
please consult the troubleshooting guide before attempting again. If problems persist please
call
(800) 232-1195 M-F 8-5 CST
.
9.
Once the engine has started,
slowly
return the choke lever all the way to the “OPEN” position.
Allow the generator to run for several minutes before attempting to connect any electrical
devices. This allows the generator to stabilize its speed and temperature.
16
Summary of Contents for 56877
Page 34: ...ENGINE EXPLODED VIEW AND PARTS LIST 31...
Page 36: ...GENERATOR EXPLODED VIEW AND PARTS LIST 33...
Page 38: ...WIRING DIAGRAM 35...
Page 40: ...NOTES 37...