![background image](http://html1.mh-extra.com/html/wen/56400ix/56400ix_instruction-manual_956377021.webp)
USING YOUR GENERATOR
CALCULATING THE WATTAGE OF YOUR DEVICE(S)
Connect electrical devices running on AC current according to their wattage requirements. Calculate the total run-
ning wattage and starting wattage of the device(s) you wish to connect, and MAKE SURE that they are within the
capacity of your generator and the capacity of each individual outlet.
Generator
Wattage
Capacity
GENERATOR RUNNING (RATED) WATTS
GENERATOR STARTING (SURGE) WATTS
3200W
4000W
What this means:
The generator can produce a maximum of
3200W on a continuous basis to supply on-
going power to your electronic devices.
NOTE:
Also check the rated amperage for
each outlet and make sure not to overload
the individual outlets.
What this means:
Some devices such as box fans require short
bursts of extra power in addition to the rated
wattage listed by the device to start their mo-
tors.
The generator can produce a maximum watt-
age of 4000W for a short period of time
(seconds) to cover the extra starting power
required by your electronic devices.
Electronic
Device
Wattage
Calculation
Find the wattage information of each device you plan to connect. The information should be
listed on the device or in its instruction manual, or you may
refer to page 22, Table 2.
The wattage can be calculated using this equation:
Watts = Volts x Amperes
To calculate the total running watts of your
devices:
+
Add up the running wattages of all the
device(s) you plan to connect.
=
The total running (rated) wattage.
This wattage should NOT exceed the run-
ning wattage of
3200W
.
It is recommended to maintain a load at or
below 2880W (90% of the rated output) to
ensure steady voltage output and to prolong
the generator’s lifespan.
To calculate the total starting watts of your
devices:
+
Add up the total running wattage of all the
device(s) you plan to connect.
+
Add the single highest ADDITIONAL start-
ing wattage out of the device(s) you plan to
connect.
=
The total starting (surge) wattage.
This wattage should NOT exceed the starting
wattage of 4000W.
If any of either of the total calculated running watts or starting watts is higher than the capac-
ity of your generator, adjust the load until both wattage requirements are met. Otherwise you
will overload the generator, and cause damage to the engine and your electrical device(s).
Table 1 - How to Calculated Wattages
21
Summary of Contents for 56400iX
Page 39: ...WIRE DIAGRAM 39...