![background image](http://html1.mh-extra.com/html/wen/56400ix/56400ix_instruction-manual_956377018.webp)
GENERATOR PREPARATION
STEP 5 - GROUND THE GENERATOR
To reduce the risk of electric shock and to maximize safety, the genera-
tor should be properly grounded.
Ground the generator by tightening the grounding nut on the front
control panel (Fig. 9) against a grounding wire. A generally acceptable
grounding wire is a No. 12 AWG (American Wire Gauge) stranded cop-
per wire.
This grounding wire should be connected at the other end to a copper,
brass, or steel grounding rod that is driven into the earth. Wire and
grounding rods are not included with the generator.
NOTE:
Grounding codes can vary by location. Contact a local electri-
cian to check the area codes.
WARNING!
Failure to properly ground the generator increases your risk of electric shock.
HIGH ALTITUDE OPERATION ABOVE 3000 FEET
The fuel system on this generator may be affected by operation at high altitudes. Proper operation can be ensured
by installing an altitude kit at altitudes higher than 2000 feet above sea level. At elevations above 7000 feet, the en-
gine may experience a decrease in performance, even with the proper altitude kit. Operating this generator without
said kit may increase the engine’s emissions and decrease both fuel economy and performance.
You can order the kit at
wenproducts.com
by searching part 56380i-HA. There are two kits - one for altitudes be-
tween 3000 and 6000 feet (56380i-HA36), and the other for altitudes from 6000 to 8000 feet (56380i-HA68). This
kit should be installed by a qualified mechanic. Refer to the instructions included with your altitude kit for more
information about installation
WARNING!
To prevent serious injury from fire, follow the kit installation procedures in a well-ventilated
area away from ignition sources. If the engine is hot from use, shut the engine off and wait for it to cool before
proceeding. Do not smoke near the generator. Warranty will be void if adjustments are not made for high altitude
use.
CAUTION:
Engines with the high-altitude kit installed operated at lower altitudes could cause severe engine dam-
age and affect emissions compliance. Be sure to uninstall the high altitude kit when operating at altitudes below
2000 feet.
After completing the above preparation, the generator is ready to be started.
Fig. 9
Grounding Nut
18
Summary of Contents for 56400iX
Page 39: ...WIRE DIAGRAM 39...