Command with FXS Gateway
Command List
24-27
-dfgw
default gateway is applied under Peer-to-Peer mode. User defines a
constant default gateway IP address, then any number dialed will pass
forward to this IP Address.
-gwtype
gateway type has two kinds, gateway and terminal.
Gateway type – device will register as H.323 defined Gateway, user has to
define [prefix] in next command.
Terminal type – device will register as H.323 defined Terminal, [prefix]
command is not necessary.
-prefix
assign Gateway prefix number, as well as the registered number on the
Gatekeeper.
-line1
assign line 1 number.
-line2
assign line 2 number.
Note:
line1 & line2 number must follow the prefix number if device is configured as
Gateway type. For example, if prefix number is 999, then the line1 & line2’s
number are 9991 & 9992.
-alias
H.323 ID. If in gatekeeper mode, this h.323 ID must be different from
others who are registering to the same gatekeeper.
-display
an addition name for user to recognize in called site.
-gkdis
Switch ON or OFF gatekeeper discovery function (1 = ON; 0 = OFF).
When it’s ON, FXS Gateway will multicast for gatekeeper if default
gatekeeper is not presented.
-rtp
to allocate RTP port range—NOT RECOMMENDED. This may be used
when RTP port range conflicts with Firewall policy.
-ttl
to set timer for TTL(Time To Live). FXS Gateway would send RRQ, with
keepAlive, to gatekeeper periodically according to TTL timer.
-gkfind
gatekeeper finding port. Port number, which FXS Gateway uses it to
discover a gatekeeper. Default value is 1718.
-gkras
To set default gatekeeper RAS port number. Default value, 1719, is
well-known port for RAS communication.
-h225 To set the ras port.(1024~65535)
-q931 To set the call signal port.(1024~65535)
-range
To allocate port range (1500-65535) FXS Gateway may use it.
-respto
Maximum response time out
-connto
Maximum connection time out
