Welch Allyn Hillrom H12+, User Manual

Page: 20 / 51

ELECTROMAGNETIC COMPATIBILITY (EMC)
16
Guidance and Manufacturer’s Declaration: Electromagentic Emissions
The equipment is intended for use in the electromagnetic environment specified in the table below. The
customer or the user of the equipment should ensure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment: Guidance
RF Emissions
CISPR 11 Group 1 The equipment uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF Emissions
CISPR 11 Class B
The equipment is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2 Not Applicable
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3 Not Applicable
Guidance and Manufacturer’s Declaration: Electromagnetic Immunity
The equipment is intended for use in the electromagnetic environment specified in the table below. The
customer or the user of the equipment should ensure that it is used in such an environment.
Immunity Test Compliance Compliance Level Electromagnetic Environment: Guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2 +/- 6 kV contact
+/- 8 kV air +/- 6 kV contact
+/- 8 kV air Floors should be wood, concrete, or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30%.
Electrical fast
transient/burst
IEC 61000-4-4 Not Applicable Not Applicable
Surge
IEC 61000-4-5 Not Applicable Not Applicable
Voltage dips,
short
interruptions,
and voltage
variations on
power supply
input lines
IEC 61000-4-11 Not Applicable Not Applicable
Power frequency
(50/60 Hz)
magnetic field 3 A/m 3 A/m Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
NOTE: UT is the AC Mains voltage prior to application of the test level.