Welch Allyn 35900-NP-TE, Directions For Use Manual

Page: 19 / 71

WARNING
Ensure that the eartip does not extend too deeply into the ear
canal. Failure to do so may cause infection.
WARNING If the probe tube becomes dirty or clogged, it must be
replaced. Failure to do so may cause injury to the ear canal or wrong results
or both.
WARNING Use only the eartips approved for use with the screener.
Failure to do so may cause injury to the ear canal.
1. Select the appropriate-sized eartip.
2. Push and slightly twist the eartip onto the probe tube.
Ensure that the eartip is fully seated on the probe. There should be no gaps between
the eartip and the collar of the probe head.
3. To remove the eartip, grasp the probe tube gently at the base and slightly twist it
while pulling the eartip off of the probe tube.
Grasping the base of the probe tube will prevent it from being inadvertently pulled
out of the probe head along with the eartip.
Probe holder
The probe holder is a receptacle attached to the HDMI cable that secures the probe
when you are not using the screener. Placing the probe into the probe holder protects
the probe head. Welch Allyn recommends that you insert the probe into the probe holder
when the screener is not in use, such as when it is on a counter top or table, or when
the screener is placed in the screener cradle.
Directions for use Setup 15