5.
5.
Check that mixer bridge is level and guide
pins (see illustration) lock smoothly without
binding. If not repeat steps
1
through
4
.
NOTE:
See Operating Instructions before operating unit.
6.
Make electrical connections (see electrical service
connections) and test mixer bridge as follows:
Þ
A/
Raise mixer bridge.
Þ
B/
Swing bridge out over centre console.
Þ
C/
Swing bridge to the left as far as possible.
Þ
D/
Lower bridge.
Þ
E/
Bridge pins should enter pin hole on kettle perfectly, If
not return to step 1 and repeat leveling steps.
Þ
F/
Raise bridge and swing to far right (for twin mixers
only).
Þ
G/
Repeat steps
D
and
E
(for twin mixers only).
7
.
Once positioned and leveled, permanently secure the
kettle's flanged feet to the floor using 5/16 inch stainless
steel lag bolts and floor anchors (supplied by the installer).
Secure each of the flanged feet with one bolt in each hole.
Seal joints of flanged feet with a silicone sealant.
MOVING UNIT
1.
While still on skid, move unit as close to final installation
position as possible.
2.
Prepare unit for lifting as shown in diagram.
3.
Lift gently with a forklift or jacks and remove skid.
4.
Lower gently to ground and remove forklift and
blocking.
5
.
If unit has to be re-positioned, slide gently. Do not twist
or push one side of unit excessively and cause
binding on trunnions.
LEVELING
1.
With straight-edge, line the backs of the consoles up with
each other (dotted line
A
).
2.
Level and straight-edge backs of consoles (dotted line
B
).
Adjustments are made by turning flanges on back feet only.
3.
Level consoles individually from front to back (dotted lines
C
).
Adjustments are made by turning flanges on front feet only.
4.
Re-check that the back is level (dotted line
B
) and then
the front (dotted line
D
). Adjust if necessary.
B
A
C
D
B
A
C
D
C
C
C
C
Postitioning
Shim as
required
to make
level with
center
console
(front
and back)
4"x4" or larger
(front and back)
Skid
Fork Lift Tongs
Flanged Feed
Jack
Note:
Instructions reflect
a more complicated twin
mixer kettle - process for
single mixer kettles is the
same.
