8
Heating Instructions
Manual Heating
1.
Turn temperature control knob clockwise to turn on the
kettle, Green light will come on.
2.
Turn temperature control knob to desired setting. (1-
10)
If Red light is on, it indicates that the water level is low in
the jacket.
With DTCI or TCR-DTCI Option
1.
Turn Controller switch to “
OFF
” if Manual heating is
desired.
See picture
#2
.
2.
Follow instructions for
Manual Heating
.
Heating
with
DTCI
option
1.
Turn Controller switch to “
ON
”. See pictures
#2
.
2.
Turn temperature control knob on the kettle to “
10
”.
See picture
#1
.
3.
DTCI will go through self-check sequence.
Note
; ZERO flashes on left indicates no sensor
selected. Buttons only adjust flashing digits.
4.
Press “
*
” to display set point.
5.
Press and hold “
*
” then press
to increase or press
to decrease the set point.
The Controller is operational with factory settings.
Heating with TCR-DTCI option
1.
Turn Controller switch to “
ON
”.
See pictures
#2
.
2.
Turn temperature control knob on the kettle to “
10
“.
See picture
#1
.
3.
Push function key “
” until “
OFF
” is displayed.
4.
Push and hold key “
” or “
” until desired
temperature is set.
5.
To start; push function key “
” until “
CtrL”
is
displayed.
6.
Push “
” key to start operation.
7.
To stop; push function key “
” until “OFF” is
displayed.
8.
Push “
” key to stop operation.
Picture
#1
Picture
#2
Picture
#3
Summary of Contents for CLEVELAND HA-MKGL-100
