Weiler E2850, Operator And Maintenance Manual, Page: 180 / 268

1
WEILER E2850 REMIXING TRANSFER VEHICLE
5-58
Maintenance
5
Maintenance Procedures
Storage Hopper Level Sensor - Check/Clean
Check sensor lens (1) for dirt and/or damage. If needed,
clean lens with a non-abrasive, non-acidic cleaner.
If damage is present, replace sensor.
Tires - Check Pressure
Inflate tires to 80 psi (552 kPa). Check tires for excessive tread wear and sidewall damage.
Toggle Switches - Check
•Check toggle switches for freedom of movement.
•Check that non-detented toggle switches spring return to neutral or off when switch lever or
rocker is released.
WARNING
Explosion and separation of tire or wheel parts can cause death or serious
injury.
• Use a clip-on air chuck with an in-line pressure gauge and a remote
air valve that allows you to stand behind the tread when inflating a
tire.
• Never stand beside the tire when inflating.
• Maintain correct tire pressure. Do not inflate tire above recommended
pressure.
• Low tire pressure can result in internal tire damage. Inflate to
recommended pressure.
• Replace any tire with cuts or bubbles. Replace any damaged wheel.
• Do not weld or heat tire and wheel assembly. Heating will increase
tire pressure.
• Only trained and qualified personnel should mount, demount, or
inflate tires.
1