上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
Specialized, Concentrated, Focused 47
G34 Bolt Hole Circle
Command Format:
G34 Xx Yy Ir Jθ Kn
Description:
Drills a circular pattern of a specified number of holes.
X, Y: the center position of this cycle (G90/91 is influential)
I: circle radius r
J:
θ, the included angle between X-axis and the point to be drilled first
K: number of holes, within -9999~9999. If the number is 0, an error report will be given. If the
number is greater than 0, hole drilling is CW, but if smaller than 0, hole drilling is CCW.
G34 drills n evenly-spaced holes on one circle with X & Y as center and r as radius, with included
angle as
θ between X axis and first hole position, G0 speed employed from one hole to another one.
10
20
30
-10
10
20
30
-10
θ
N001 G91 G81 G99 Z-5 R6 F500 K1
N002 G34 X10 Y10 I20 J45 K8
The machine tool starts drilling from
position 1 until to position 8.
The included angle is
θ
between position 1
and positive direction of X axis. Drilling
actions are specified by G81 in program
block N001.
1
2
3
4
5
6
7
8
Fig. 4-33 Sketch Map of Bolt Hole Circle
G35 Holes on Line at Angle Cycle
Command Format:
G35 Xx Yy Id Jθ Kn
Description:
Drills holes on a line at an angle with respect to X-axis.
X, Y: the initial position to be drilled (G90/91 is influential)
I: distance (d) between adjacent holes. If the value is minus, drilling holes in symmetry direction.
J: a
ngle θ, specifying the angle of the line holes to be drilled on.
K: number of holes, within 0~9999. If the number is 0, an error report will be given.
G35 drills n evenly-spaced holes on a line at an angle with respect to X axis, with X and Y as
initial position, d as spacing distance between adjacent holes, G0 speed adopted when moving from
one hole to another one.
Summary of Contents for Ncstudio
Page 74: ...RMB 21 00 ...
