User Manual v1.9
Manual
WI-I/O 9-K
v1.9
Page 29
3.4.2
Battery Pack WI-BP-I/O-9-K
The WI-BP-I/O-9-K can be installed underneath the WI-I/O K or beside it.
The WI-BP-I/O-9-K uses the same type of enclosure as the WI-I/O K and is
mounted in the same way. The WI-BP-I/O-9-K has a “cable tail” which
plugs into the WI-I/O K. The input wiring is then connected to a socket on
the WI-BP-I/O-9-K.
The lid of the WI-BP-I/O-9-K can be rotated to suit installation.
A second WI-BP-I/O-9-K can be connected to the first in a similar manner.
The input wiring for the WI-I/O K is then connected to the socket on the
second WI-BP-I/O-9-K.
All plugs and connectors should be waterproofed with waterproofing
tape.
Check the label on the back of the WI-BP-I/O-9-K to make sure that it has been factory-set to 9V
(model WI-BP-I/O-9-K-2).
The WI-BP-I/O-9-K takes six alkaline AA batteries - such as Duracel MX1500 or Eveready E91.
Do not use rechargeable batteries in the WI-BP-I/O-9-K as their self discharge life is short. The
temperature rating of the WI-BP-I/O-9-K depends on the battery type - for alkaline batteries, this
OK
TX
INPUT
WIRING
