11
8. Using a plastic bag to keep your fingers clean,
apply some of the included grease to an M10 x
57mm Bolt Set (80).
Orient the Leg Lever (13) so that the high end of
the bracket is in the location shown.
Attach the Leg Lever (13) to the Leg (10) with the
M10 x 57mm Bolt Set (80).
Make sure that the
barrel of the Bolt Set is inserted through both
sides of the bracket on the Leg.
8
80
13
80
10
Grease
High
End
9
9.
IMPORTANT: See the CABLE DIAGRAM on
page 39. Cut along the dotted line, and lay
the CABLE DIAGRAM beside this manual for
reference while you assemble the cables and
the pulleys.
Identify the Burn Cable (45).
Next, identify the four Burn Pulleys (68), the
three V-pulleys (not shown), and the twenty
Pulleys (not shown).
Route the threaded end of the Burn Cable (45)
through the large bracket on the Base (1) as
shown.
Attach a Burn Pulley (68) above the Burn Cable
(45) inside the large bracket with an M10 x
63mm Bolt (89), two 12.7mm Spacers (73), and
an M10 Locknut (74).
89
73
73
74
Threaded
End
1
68
45
10. Attach a second Burn Pulley (68) above the Burn
Cable (45) inside the large bracket on the Base
(1) with an M10 x 63mm Bolt (89), two 12.7mm
Spacers (73), and an M10 Locknut (74).
10
89
73
73
74
1
68
45
Summary of Contents for 831.14923.1
Page 40: ...40 NOTES...
