Wegener UNITY4650, User Manual

Page: 66 / 92

Unity 4650 User’s Manual
800034-01 Rev. A 66 wegener.com
SET [parameter] [value]
SET TO [destination] [time]
SET FROM [source]
parameter : One of format , feed , freq [for “carrier freq”], rate [for “data rate”],
FEC , tag [for “tag site”], prog [for “program”], margin [for “Eb/No margin
warning zone”], aud1 , or aud2 [for “descriptors assigned to audio ports 1 and
2”]. See PERM and ADDE commands for definitions and limits.
value : Value of the parameter as in any settings command (PERM, TEMP,
ADDS, etc.)
destination : PERM, TEMP, number or label of a table entry.
time : Length of insert in either HH:MM:SS format (valid range is 0:00:00 to
18:00:00, leading zeros OK to omit on hours) OR in number of seconds. (A
one-hour TEMP could have a parameters: of 1:00:00 or 3600.)
source : PERM, CURR, number or label of a table entry.
SET sets the value of individual parameters in a ‘scratch pad’ settings group.
SET TO will store the scratch pad settings to a search table entry or to the per-
manent or temporary settings (requires an insert time as a second parameter).
SET FROM loads the scratch pad settings from a search table entry or from
the current or permanent settings.
SETAUDIO port route [program] [atten]
program : Can be a three character name or an ‘*’. If the 3-character name is
specified, the unit will route the audio PES stream with the specified name to
the port. If ‘*’ is specified, the unit will default to the first audio program in the
PMT that is not routed to another port.
port : Value of 1 to 6 indicating an audio port
route : S - Stereo (Left and Right components routed as con-
nected at original MPEG encoder)
1 - Original Left component to both L and R outputs
2 - Original Right component to both L and R outputs
M - Sum of Left and Right components to both L and R
outputs
R - Reverse of “Stereo” above (if allowed by hardware)