WEG CFW501, User Manual, Page: 23 / 149

18 | CFW501
Installation and Connection
E
ng
lis
h
Connector Description (**)
Top
c
onne
ct
ion
1 DO1-RL-NO
Digital output 1
(NA Contact of relay 1)
3 DO1-RL-C
Digital output 1
(Common point of relay 1)
5 DO1-RL-NC
Digital output 1
(NF Contact of relay 1)
7 DO3-RL-NO
Digital output 3
(NA Contact of relay 2)
9 DO3-RL-C
Digital output 3
(Common point of relay 2)
11 DO3-RL-NC
Digital output 3
(NF Contact of relay 2)
13 NC Not connected
15 +24 V Power 24 Vcc
17 DI1 Digital input 1
19 DI2 Digital input 2 (*)
21 DI3 Digital input 3
23 DI4 Digital input 4
B
ot
tom
c
onne
ct
ion
2 AO1 Analog output 1
4 GND Reference 0 V
6 AI1 Analog input 1
8 +10 V Ref10 Vcc for potentiometer
10 DO2-TR Digital output 2 (transistor)
12 RS485 - A RS485 (Terminal A)
14 RS485 - B RS485 (Terminal B)
16 GND Reference 0 V
18 AI2 Analog input 2
20 RS485 – A(2) RS485 (Terminal A2)
22 RS485 – B(2) RS485 (Terminal B2)
24 GND Reference 0 V
(*) The digital input 2 (DI2) can also be used as input in frequency (FI). For further details refer to the
programming manual of the CFW501.
(**) For further information, refer to the detailed specification in section 8.2 Electronic/General Data .
Figure 3.4 (b): Signals of the connector of the CFW500-CRS485 plug-in module
The location of the plug-in module and DIP-switches to select the type of analog input
and output signal and the termination of the RS485 network is shown in figure A.2 .
The CFW501 inverters are supplied with the digital inputs configured as active low (NPN),
analog input and output configured for signal in voltage 0...10 V and with termination
resistor of the RS485 OFF.
NOTE!
„
To use the analog inputs and/or outputs with signal in current, you must
set the switches S1 and S2 and the related parameters as per
table 3.2 .
For further information, refer to the CFW501 programming manual.
„
To modify the digital inputs from active low to active high, check the
use of parameter P0271 in the CFW501 programming manual.