WEEDO F192, User Manual

Page: 19 / 57

17 18
GB
5.1.4. Printing Parameters Settings
Click “Expert” on the menu bar
→
“Switch to full settings… ”, go into the complete
setting interface, as shown in figure below.
Red Box is Printing Quality Parameter.
Layer height: is the printing precision we usually refer to, and is generally chosen
between 0.1 and 0.25, the smaller the data is, the higher the model precision is.
External shell layer thickness: the thickness of outermost surface can improve the
surface quality, and is multiple of nozzle size (is also the multiple of 0.4)
Black Box is Stuffing Parameters.
Bottom and top thickness: the thickness of model bottom layer and top layer, it is
suggested to use the same parameter as the external shell.
Packed density: It refers to packed density of model. The interior of model is not
completely packed, and it would not affect the surface quality, but affect the
intensity only.
Blue Box is Speed and Temperature Parameters
Printing speed: If the printing object is relatively small, please use the low speed.
Printing temperature: it refers to the temperature of printing spray-head, the
temperature to print the PLA/PLA pro consumables is 190-210 degree.For
Dual-extruder printer it may be 170-190degree.
Green Box is Support Parameters
Support type: shown as figure below, “None” refers to not use the support,
“Touching build plate” is external support, “Everywhere” is complete support, the
support type can be choose according to the model suspending in the air.