Weco WF-107, Instruction Manual, Page: 18 / 32

Cod.006.0001.1260
10/07/2017 v2.14
ENGLISH
WF-107
18/32
11.1.2 MIG/MAG PARAMETERS SETTING (2ND LEVEL)
S1 Hold down the button for 3 seconds to gain access to the 2nd level menu.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
E1 Use the encoder to scroll the list of settings to edit.
E2 Using the encoder, edit the value of the selected setting.
Press any button to save the setting and quit the menu.
Tab. 7 - 2nd level menu parameters in MIG/MAG mode
ACRONYM PARAMETER MIN DEFAULT MAX
t.On TIME ON 0.5 s 1.0 s 25.0 s
T.oFF TIME OFF 0.5 s 1.0 s 25.0 s
H.-S. HOT START 1 % 130 % 200 %
C.-F. CRATER FILLER 1 % 130 % 200 %
S.3L. 3 LEVELS SLOPE 0.1 s 0.5 s 10.0 s
S.-S. SOFT START 10 % 30 % 100 % *1
SLO. MOTOR SLOPE 0 ms 40 ms 200 ms *1
b.-b. BOURN BACK 0 ms 16 ms 200 ms *1
11.1.3 MIG/MAG PARAMETERS SETTING (GAS MENU)
S3 Hold down the button for 3 seconds to gain access to the 2nd level menu.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
E1 Use the encoder to scroll the list of settings to edit.
E2 Using the encoder, edit the value of the selected setting.
Press any button to save the setting and quit the menu.
Tab. 8 - Gas menu parameters in MIG/MAG mode
ACRONYM PARAMETER MIN DEFAULT MAX
Po.G. POST GAS TIME 0.0 s 0.3 s 10.0 s *1
Pr.G. PRE GAS TIME 0.0 s 0 s 10.0 s *1
*1: When a synergic program is loaded the default value of the parameter is defined automatically by the software and the message "SYN" will
be shown on the display.