Page
8
of
17
8.
REPLACEMENT OF THE CUTTING BLADE
First withdraw the anvil as described above.
Pump out the main ram until the blade retaining pins 030636 can be seen in the opening of the
cutter body.
Drift out the pins 030636 and slide the blade 705051C out of the tool.
Gloves may be worn to protect the hands when removing the blade from the tool
When refitting the new blade ensure the retaining pins are below the surface of the ram on
both sides.
9.
REMOVAL OF THE MAIN CYLINDER
If it is necessary to renew the hydraulic seals, first remove the blade as described above in
section 8, the cylinder must then be removed from the tool. As an aid to this, remove the 2
blanking screws 035114, then a bar is to be fastened to the top of the cylinder using the 2
tapped holes, apply a torque and not a bending moment when unscrewing the cylinder. The
