Page
14
of
17
OPTIONAL COMPLETION KIT 999021 FITTED TO HCV155
This is a special manifold block unique to the HCV155, fitted with intensifier and hoses, the
manifold has two connections for the blade movement on the side and two on the top for
activating the anvil in and out. All connections are clearly marked. if the intensifier is removed it
is important that it is replaced in exactly the same position, the manifold block is marked with
“R” and “IN” this corresponds with the same markings on the bottom of the intensifier.
The intensifier has 2 pins in the bottom, each has a seal, to replace the seals remove the 4 nuts
holding down the intensifier captive plate, remove the intensifier, the seals are now accessible.
Below is shown the cutter fitted with a completion kit, a side plate has been removed to show
more clearly the hose connections
The hoses connected to the main cylinder are rated at 700 bar, those for the auxiliary cylinders
are rated at 400 bar.
The couplings for the cutting stroke and return stroke are 7/16” JIC all other couplings in the
manifold block are ¼” BSP
