Page
7
of
17
The cylinder is a pressure vessel and should not be drilled, machined, mutilated or damaged in
any way for mounting purposes or to assist in its removal for servicing, any warranty could be
invalidated by such actions. Also see section 9
The use of stilsons to remove the cylinder is not recommended as damage will occur.
7.
REPLACEMENT OF THE ANVIL
Loosen the four screws 035079 and the set screw 035073. Attached a screw to the Pivot Pin
761265 and pull free.
The lever will now be free, lift it free from the anvil SSC6489
The anvil SSC6489 may now be removed from the body.
Re-assembly is the reverse of the above process.
