Ford F-250/350 Super Duty Truck
11
Heater Preparation and Installation
ATTENTION
Observe torque specifications.
Install heater mounting bracket on heater.
– (1) Heater mounting bracket
– (2) M6 EJOT screw (3 ea.) Torque 10 Nm (88.5 lb-in.)
ATTENTION
If the vehicle is not equipped with running boards,
install panel nuts provided using the existing holes in
the cab.
Position the heater in it’s mounting location.
Align the holes in the rear of the mounting bracket with
the panel nuts previously installed or existing hardware
used to secure running boards and mark the front
mounting hole location on the cab.
Set heater aside and drill the front mounting hole.
– (1) Front mounting hole location (5/16 in. hole)
– (2) Cab body (behind front right wheel)
– (3) Panel Nuts
Heater Mounting
ATTENTION
Use existing hardware to secure the heater if the
vehicle is equipped with running boards (See Figure 1).
Connect heater harness to heater (not shown).
Install heater on cab with hardware provided.
– (1) M8 bolt, washer, panel nut (2 ea.)
– (2) Heater/mounting bracket assembly
ATTENTION
Pull the inner fender splash shield back to install the
front mounting hardware.
Install the front mounting hardware.
– (1) Heater/mounting bracket
– (2) M8 bolt, washer, and flange nut
Fig. 15
2
1
Fig. 16
1
2
3
Fig. 17
1
2
1
Fig. 18
1
2
