www.weaverleathercraft.com
26
To achieve the best results, we recommend punching a
few holes in some scrap leather using the troubleshooting
tips on page 27 as your guide.
1) Secure the anvil with the set screw located at the front on the anvil
adapter using a 5/32" Allen wrench
(Figure 120)
, and secure the
threaded punch handle with the thumb screw on the driver shaft
(Figure 121)
. Adjust the driver up by turning adjustment wheel
clockwise or down by turning counterclockwise
(Figure 122)
.
2) Screw hole punch tube (size 5, 6, 7, 8, 9 or 10) onto the threaded
punch handle
(Figure 123)
.
3) Insert leather or material that you are using.
4) Pull the handle forward until hole is punched
(Figure 124)
.
FIGURE 120
FIGURE 121
FIGURE 123
FIGURE 124
Punching Holes
FIGURE 122
Actual Size of Hole Punch Tubes
5 6 7 8 9 10
3
⁄
32
"
7
⁄
64
"
1
⁄
8
"
5
⁄
32
"
11
⁄
64
"
3
⁄
16
"
FIGURE 125
FIGURE 126
FIGURE 127
USING THE METAL GUIDE
A metal guide
(Figure 125)
is included
with the Little Wonder
®
to help you
maintain consistency when using Little
Wonder
®
attachments. Loosen the thumb
screw on the right side of the machine
and adjust guide until it rests on the edge
of your strap
(Figure 126)
. Tighten thumb
screw to keep guide in place
(Figure 127)
.
