www.weaverleathercraft.com
14
You do not need to pre-punch holes in your material to set spots.
To achieve the best results, we recommend testing a few spots
in some scrap leather using the troubleshooting tips on page 15
as your guide.
1) Insert the appropriate anvil and spot setter attachment for the spot you
want to set (1/8", 3/16", 1/4", 5/16", 3/8" or 1/2"). Secure the anvil with
the set screw located at the front of the anvil adapter using a 5/32"
Allen wrench
(Figure 40)
. Insert the spot setter attachment into the
driver shaft and secure with the thumb screw
(Figure 41)
.
2) It is important to obtain the proper distance between the anvil and the
driver. Turn clockwise to raise the driver or counterclockwise to lower
the driver
(Figure 42)
.
3) Place the spot into the driver
(Figure 43)
.
4) Insert leather or material that you are using.
5) Pull the handle forward until the spot is set
(Figure 44)
.
FIGURE 40
FIGURE 41
FIGURE 43
FIGURE 44
FIGURE 45
FIGURE 46
FIGURE 47
USING THE METAL GUIDE
A metal guide
(Figure 45)
is included
with the Little Wonder
®
to help you
maintain consistency when using Little
Wonder
®
attachments. Loosen the thumb
screw on the right side of the machine
and adjust guide until it rests on the edge
of your strap
(Figure 46)
. Tighten thumb
screw to keep guide in place
(Figure 47)
.
Setting Spots
FIGURE 42
