www.weaverleathercraft.com
24
Will not work with 1/4" 2200 rivets
Holes need to be punched before setting; a 3/32" hole should work
for all sizes. To achieve the best results, we recommend testing a
few rivets in some scrap leather using the troubleshooting tips on
page 25 as your guide.
1) Insert the 1B setter into the anvil adapter and secure with the set
screw using a 5/32" Allen wrench
(Figure 113)
. Adjust the driver
up by turning adjustment wheel clockwise or down by turning
counterclockwise
(Figure 114)
. Insert the 1T driver into the driver
shaft and secure with the thumb screw
(Figure 115)
.
2) Place the rivet into the 1B setter
(Figure 116)
. Place the cap into
the 1T driver flat side up
(Figure 117)
.
3) Insert leather or material that you are using.
4) Pull the handle forward until set
(Figure 118)
.
FIGURE 113
FIGURE 114
FIGURE 116
FIGURE 118
FIGURE 117
Setting Double Cap, Jiffy and Rapid Rivets
FIGURE 115
1B
1T
