WDS 1710 Series, Technical Manual

Page: 28 / 62

DTYPE [NODE/ROOT]
Details Page 26
(
Diagnostics
) Sets up a radio as a root or node
radio.
DUMP Details Page 26
Display all programmable settings.
HREV Details Page 27
Display the Hardware Revision level.
INIT Details Page 27
Set radio parameters to factory defaults.
INIT [x710] Details
Page 27
Configure radio for use
outside
of P-20 chassis.
Restores certain transceiver defaults changed by
the
INIT x720
command.
INIT [x720]
Details
Page 27
Configure radio for service
within
a P-20
redundant/protected chassis.
KEY Details Page 28
Key the radio (transmitter ON). This is generally a
radio test command.
MODEL Details Page 28
Display the model number of the radio.
MODEM [xxxx, NONE]
Details Page 28
Set the modem characteristics of the radio.
OWM [XXX...] Details Page
28
Set or display the owner ’ s message.
OWN [XXX...] Details Page
28
Set or display the owner ’ s name.
PTT [0
–
255] Details Page
28
Set or display the Push-to-Talk delay in
milliseconds.
PWR [20
–
37] Details Page
28
Set or display the transmit power setting.
RSSI Details Page 29
Display the Received Signal Strength Indication.
RTU [ON/OFF/0-80] Details
Page 29
Re-enables or disables the radio ’ s internal RTU
simulator and sets the RTU address.
RX [xxx.xxxx] Details Page
29
Set or display receiver frequency.
RXLEVEL [
–
20 to +6]
Details Page 30
Set or display the receive audio input level.
RXTOT [NONE, 1-1440]
Details Page 30
Set or display the value of the receive time-out
timer.
SCD [0-255] Details Page
30
Set or display the Soft-Carrier Dekey delay in
milliseconds.
SER Details Page 30
Display the radio serial number.
SHOW [DC, PORT, PWR]
Details Page 30
Display the DC voltages, diagnostics port, and
transmit power level.
SREV Details Page 31
Display the Software Revision Level.
STAT Details Page 31
Display radio status and alarms.
TEMP Details Page 31
Display the internal temperature of the radio in
degrees C.
TOT [1-255, ON, OFF]
Details Page 31
Set or display the Time-out Timer delay in
seconds.
Table 9. Command Summary (Continued)
Command name Function
20 05-3305A01, Rev. E